Toronto Metropolitan University
Patel_Dineshkumar.pdf (8.15 MB)

Using tomography, CFD, and dynamic tests to study the continuous-flow mixing of yield-pseudoplastic fluids

Download (8.15 MB)
posted on 2021-05-24, 15:02 authored by Dineshkumar Patel
The major technological challenges faced by modern chemical industries are non-ideal flows such as dead zones and channeling encountered in the mixing of fluids with complex rheology. These cause sub-optimal mixing and lead to low quality products and high costs of raw materials. Therefore, the core objectives of this study were to develop methodology and tools to design an efficient continuous-flow mixing system for the fluids with complex rheology using electrical resistance tomography (ERT), computational fluid dynamics (CFD), and dynamic tests. The xanthan gum solution, which is a pesudoplastic fluid with yield stress, was used to study the dynamic behavior of the continuous-flow mixing process. The power consumption, cavern size, mixing time, and the extents of channelling and the fraction of fully mixed volume were successfully determined using dynamic tests, ERT tests, and CFD simulations and used as mixing quality criteria. A novel and efficient method was developed for flow visualization in the continuous-flow mixing of opaque fluids using 2D and 3D tomograms. A unique study on identifying the sources of flow non-ideality in non-Newtonian fluids with yield stress was done by visualizing the flow pattern inside the continuous-flow mixing vessel using 2D and 3D tomograms. The deformation of the cavern was analyzed and quantified in the continuous-flow mixing system for yield-pseudoplastic fluids using ERT. Moreover, the cavern volume was compared with the fully mixed volume and it was found that the latter was higher due to the extra momentum induced by the inlet-outlet flow. A novel study on exploring the effect of the rheological parameters of the pseudoplastic fluids with yield stress on the non ideal flows in a continuous-flow mixing system was performed using CFD. The CFD results revealed that the mixing quality was improved when the degree of the shear thinning was increased. The ratio of the residence time to the batch mixing time was evaluated to achieve ideal mixing for the continuous-flow mixing of yield-pseudoplastic fluids using dynamic tests and ERT. It was found that the ratio of residence time to the batch mixing time should be at least 8.2 or higher to achieve ideal mixing.





  • Doctor of Philosophy


  • Chemical Engineering

Granting Institution

Ryerson University

LAC Thesis Type

  • Dissertation



Usage metrics

    Chemical Engineering (Theses)


    Ref. manager